I am developing a Beacon model application with ST bluetile. Bluenrg2 low power current consumption differs between SensorDemo (200uA) and Beacon application (1.8mA). I made sure that the bluetile goes into SLEEP_NO_TIMER mode and wakes up only when ...

I have two STM32L471 custom design board. Both of them are not getting detected with stlink neither via jtag not swd. But, i am able to program the flash using the bootloader mode. Is there any way to recover the swd/jtag. I need at least one of them...

Stm workbench shows jtag failure -4 when trying to set two gpio pins to high. One connected to boost conveter(enable) and other to telit modem on off.Is there any other settings I have to do to fix this error.Chip: stm32l471reGpio: port b, pin 0 and ...