How can i assign addresses in EEPROM code of BlueNRG 232 for different vaiables location.As in the sample code bluenrg232 only device address is used not the register address where we will save varaible values memory.function taken from sample i2c ...

Our test eeprom code taken from samples codes with address Flash begin address 10040000 worked but not getting reprogram until boot pin gnd to 3.3v then gnd.Flash address 10042850 is working but creating problem to reprogramThen we tried 1007000,1006...

can we generate basic code for blue nrg 232 using blue nrg gui with out hardware module, any evaluation board. 

how to configure blue nrg 232 so io pinCan we generate c code for blue nrg 232 soc from cubemx 

IDE support for BluenRG232 programming ishttps://www.st.com/en/embedded-software/stsw-bluenrg1-dk.htmlWhich other IDE gives support for Blue-nRG232 SOC programming?Can I use Cube ide or IAR platform or TrueStudio for programming the ST Blue nRG232?