About SGior.1

SGior.1 · 2020-03-31

It's the first time that I have to set RF modules.I have the following RF modules: S2LP of ST and CC1101 of Texas. I need that they communicate togethar. Do you know if they are compatible?I know that in the module C1101 you can select 2GFSK modulati...

SGior.1 · 2020-03-24

I’m not RF expert and I know that my question is very very general.I have to communicate with RF S2LP device using a not ST microcontroller, but at the moment my firmware can read and write the S2LP registers by SPI. It works correctly.The RF CC1101 ...

SGior.1 · 2020-03-30

Hi Winfred,Thank you for your answer.Here you are my answers: 1. The XTAL frequency is 50MHz; 2. The channel filter is 100kHz; 3. Data whitening and FEC are both enabled. In my code I disabled the CRC check to do some tests. Anyway the CRC should be ...

User statistics

User Activity

S2LP and CC1101 compatibility

I have to develop a project using ST microelectronics 868MHz S2LP device and Texas Instruments CC1101. They have to communicate on 7th channel (868,3MHz) with baud rate 19200 bps.

Re: I have to develop a project using ST microelectronics 868MHz S2LP device and Texas Instruments CC1101. They have to communicate on 7th channel (868,3MHz) with baud rate 19200 bps.