FAQs
Chandu
Associate II
since ‎2019-07-08
‎2023-06-14

User statistics

  • 5 Posts
  • 0 Solutions
  • 0 Kudos given
  • 0 Kudos received

User Activity

How to test STM32F469AI of packaging type WLCSP168 if its receiving power?

2019-07-23
Hi everyone,I have the STEVAL-IDP005V1 sensor board on which STM32F469AI MCU is present. I suspect that something is wrong with the D9 pin of MCU which is supposed to receive 3.3V from the power management unit on the board which I tested to be up an...

cannot initialise target MCU on STEVAL-IDP005V1

2019-07-23
I am using STEVAL-BFA001V1B evaluation kit where I am trying to initialize the MCU on sensor board present in the kit. I have connected ST-LINK/V2-1 programmer/debugger to the sensor board via an adapter board present in the same kit. The ST-LINK/V2-...

The interface firmware FAILED to reset/halt the target MCU FAIL.TXT message on my STEVAL-IDP005V1. How do I fix this?

2019-07-10
I have connected STEVAL-IDP005V1 sensor board (it has an STM32F469AI ARM® Cortex®-M4 32-bit MCU on it) to the ST-LINK/V2-1 programmer/debugger on stm32 NUCLEO-F401RE board via an adapter board STEVAL-UKI001V1. When I connect the USB cable to the PC a...

Unable to load .bin file due to absence of claimed flash memory on STEVAL-IDP005V1.

2019-07-08
Hello everyone,I am trying to load an example .bin file obtained from 'Environmental_Monitoring', an example application present in 'en.stsw-bfa001v1' software package for STEVAL-BFA001V1B predictive maintenance kit. However when I connect the USB ca...
Top