About Aabde.1

Aabde.1 · 2020-09-07

Aabde.1 · 2020-03-17

Aabde.1 · 2020-09-08

set it with logic 0 and set it with logic 1 and then set it with 0 again

Aabde.1 · 2020-09-08

Hello peter ,thank you for reply ,but if i am not using the parallel and i am using "Via 8-bit SPI " do i need to do reset also or the fault can be eliminated by other way, take in consideration that when i apply a failure on a specific output pin ...

User statistics

User Activity

for L9826 chip when apply 13v and "output shorted to Vbat" is detected , when remove this fault the output remain pulled high , so is there is any steps needed to be applied to recover from this failture ?

for L9826 chip datasheet, what is the Status-bit stated in "Table 7. Diagnostic Table for outputs 1 to 8 in SPI controlled mode" and for this bit is in which register, and is it is send to the micro controller through the SDO?

Re: for L9826 chip when apply 13v and "output shorted to Vbat" is detected , when remove this fault the output remain pulled high , so is there is any steps needed to be applied to recover from this failture ?

Re: for L9826 chip when apply 13v and "output shorted to Vbat" is detected , when remove this fault the output remain pulled high , so is there is any steps needed to be applied to recover from this failture ?