About HClau.1

HClau.1 · 2020-08-31

The chip is powered by an 3v3 LDO. I have measured the output, and there are no fall-outs. I suspect my I2C adapter to be doing it. On-board the I2C is pulled up to 3v3 by 2k2 resistors. But on the adapter the I2C gets pulled up to 5V also by 2k2 res...

HClau.1 · 2020-09-06

Hi,I have been testing for while now.First, removing the pull-up resistors from the adaptor did the magic regarding the stability of the sensor.Second, I have gotten interupts from negative accelerations now thank you. I did what you said and enabled...

HClau.1 · 2020-09-03

We're getting there :)Is it necessary to enable AOI also?

HClau.1 · 2020-09-02

Hi again.I'm trying to trigger on a negativ acceleration. It seems like I can't enter a negativ threshold ?

HClau.1 · 2020-09-01

Hi, I've looked through an app note for the negative thresholds. Seems like I have to enable 6d, is that correct?Regarding the adapter. It's home-made. But I believe you're correct, because I stripped the adapter for pull-ups, and it have been runnin...

User statistics

User Activity

I'm using a LIS2DE12 for sensing the opening and closing of doors. 1) The chip is resetting randomly when I communicate with over I2C. 2) I need to trigger an interupt a deceleration (negative acceleration), but can't put in a negative thredshold.

Re: I'm using a LIS2DE12 for sensing the opening and closing of doors. 1) The chip is resetting randomly when I communicate with over I2C. 2) I need to trigger an interupt a deceleration (negative acceleration), but can't put in a negative thredshold.

Re: I'm using a LIS2DE12 for sensing the opening and closing of doors. 1) The chip is resetting randomly when I communicate with over I2C. 2) I need to trigger an interupt a deceleration (negative acceleration), but can't put in a negative thredshold.

Re: I'm using a LIS2DE12 for sensing the opening and closing of doors. 1) The chip is resetting randomly when I communicate with over I2C. 2) I need to trigger an interupt a deceleration (negative acceleration), but can't put in a negative thredshold.

Re: I'm using a LIS2DE12 for sensing the opening and closing of doors. 1) The chip is resetting randomly when I communicate with over I2C. 2) I need to trigger an interupt a deceleration (negative acceleration), but can't put in a negative thredshold.