About JMora.7

JMora.7 · 2022-04-18

Hello I ordered two NUCLEO boards, to start some projects on the ST32G03 platform. I was using the board with out an issue and connected to am Ubuntu 20.04 sys, updated the firmware on both and now one is working and the other is not, here is an outp...

JMora.7 · 2022-04-24

Well, I tried going back to an older firmware and it did not work. st-info --probe Found 1 stlink programmers version: V2J38S27 serial: 066EFF3933354D5043120830 flash: 0 (pagesize: 0) sram: 0 chipid: 0x0000 descr: ...

JMora.7 · 2022-04-19

Thank you for your recommendation, I could have sworn I tried that, but I have to double check, Any specific procedure I need to take to ensure this is done correctly? Thank you.

JMora.7 · 2022-04-18

Hi, I’m in the same situation here, brand new Nucleo board, and I get the following with st-info — probe setting new configuration (0 -> 1) Found 1 st-link programmers seria: XXXXXXXXXXXXXXXXXX < Edit flash: 0 (pagesize: 0) sram: 0 chipid: 0x0000 ...

User statistics

User Activity

How to fix ST-Link Nucleo board unable to connect, where the target is not found and the st-link is showing chipid 0x0000

Re: How to fix ST-Link Nucleo board unable to connect, where the target is not found and the st-link is showing chipid 0x0000

Re: How to fix ST-Link Nucleo board unable to connect, where the target is not found and the st-link is showing chipid 0x0000

Re: STM32L496G-Discovery Unknown Device