FAQs
Ypinh.1
Associate III
since ‎2022-01-06
‎2023-06-14

User statistics

  • 15 Posts
  • 1 Solutions
  • 0 Kudos given
  • 0 Kudos received

User Activity

How to jump to an application without reinit all previous initial modules

2022-07-05
Hello guys, First i would like to thank you about your products and all the knowledge you share from your rich experience with us, really appreciate and helpful.I am using STM32L412RBPT evaluation board.This MCU has only 1 bank in the nvm of 128KByte...

Nucleo - STM32L412RB-P: How to measure IDD only through STM32 Microcontroller?

2022-01-13
I have generated minimal code using cubeMX that i enter stop2 mode and never wake up.i added some functions to decrease power consumption and tried to combine between them in order to see how the idd measurements changes.among the functions:killing t...

for the STM32l412 MCU - Is it possible to get LPUART interrupt while write & erase page on the internal NVM flash?

2022-01-06
when performed NVM operations (write on page and erase page), i lost some recieved bytes in my LPUART Rx line.when i uncomment the part of writing on the nvm, the lpuart works fine.can any one please tell me if there is a way to use this modules toge...

Cannot read low current consumption on STOP2 mode with my STM32L412 board (~300uA+-), but using the same code and compatible with my STM32L476, i succeed (~3uA). ill be happy to work with low consumption with the STM32L412, can any one help me with that?

2022-01-06
Hello guys, first, i would like to thank you about this forum i used a lot and got good suggestions and i learn a lot from you.About my problem:I checked a lot in the internet and see others that had the same problem like mine, but didnt find any wit...
Top