About ARana.2

ARana.2 · 2021-12-30

I have made one MASTER and one SLAVE using B-L072Z-LRWAN1 ST board. I'm using Lora Phys layer to establish peer to peer network. I have modified Ping-Pong example. Task: I'm trying to achieve communication between MASTER and multiple SLAVE (typically...

ARana.2 · 2022-01-09

Hello @Community member Thanks, :grinning_face: I'm able to establish network between master and multiple slave, master is hoping between different channels on fixed spreading factor. I'm able to send and receive 64 bytes payload, But due to some re...

ARana.2 · 2021-12-30

Thanks for your reply, I'm using radio.rx(0) (no time out for RX) for listening continuously on master side. As of now i'm using continuous RX and one timer to switch between channels. I have also tried RX_TIMEOUT (5 seconds), when the RX_TIMEOUT occ...

ARana.2 · 2021-12-30

hello @Community member Thanks for your reply, I have made one MASTER and one SLAVE using B-L072Z-LRWAN1 ST board. I'm using Lora PhY layer to establish peer to peer network. I have modified Ping_Pong example. Task: I'm trying to achieve communicati...

ARana.2 · 2021-12-28

@Community member Hello There. I have tested the Ping Pong example and it's working fine for two device. Now I want to modify the code in such a way that one become master and always in listening mode. and the slave send messages to the master. but...

User statistics

User Activity

is it possible to change the channel in lorawan board B-L072Z-LRWAN1 in run time in ping pong example?

Re: is it possible to change the channel in lorawan board B-L072Z-LRWAN1 in run time in ping pong example?

Re: Can B-L072Z-LRWAN1 Build A Lora Network?

Re: Can B-L072Z-LRWAN1 Build A Lora Network?

Re: Can B-L072Z-LRWAN1 Build A Lora Network?