About Srave.1

Srave.1 · 2022-09-15

I tried updating the driver by right-clicking on the listed port. It shows already updated the best driver. Does anyone know how to fix this?

Srave.1 · 2021-12-20

Hi,I am currently working on a project which requires to save 127 bytes of configuration parameters to EEprom. Micro controller is stm32l552x series. We have emulated eeprom from flash using X-CUBE-EEPROM_V3.0.0 software package to store configuratio...

Srave.1 · 2022-09-19

Hi Imen,Thank you for the response. I have changed the USB cable several times and also updated the ST -Link firmware. Still it shows No ST link detected.

Srave.1 · 2021-12-23

After some testing, Following is my understanding.Reading a virtual address location continuously which was not previously written by any values is making the stuck issue. Then the code stuck in the following loop inside eeprom emulation driver. Th...

Srave.1 · 2021-12-21

Even though we use 127 byte location in eeprom, we are updating only first 76 byte location(virtual address from 1 to 76) frequently. 1 to 76 byte virtual address locations are used to store parameter value and the 127 th location is used to store ch...

Srave.1 · 2021-12-20

Hi Uwe Bonnes,Thanks for your comments. Frequency is very less in normal case. But for aggressive testing we were updating and reading 127 bytes of parameters data(Each parameter of 1 byte) frequently.we have been testing the application in 2 STM boa...

Srave.1 · 2021-12-20

When I changed #define START_PAGE_ADDRESS 0x08020000U to 0x 0x0807B000U in configuration file, I could resolve EE_Init() stuck issue. But eeprom stuck during continuous read operation.

User statistics

User Activity

Hi All, I am working with STM32 NUCLEO-L552ZE-Q board and the IDE is STM32 cube IDE 1.6.1. When I try to load the code no stlink detected error message pops up. In device manager, under ports jlink CDC UART port is listed.

EEPROM emulation Fails after constant Read and Write operation.

Re: Hi All, I am working with STM32 NUCLEO-L552ZE-Q board and the IDE is STM32 cube IDE 1.6.1. When I try to load the code no stlink detected error message pops up. In device manager, under ports jlink CDC UART port is listed.

Re: EEPROM emulation Fails after constant Read and Write operation.

Re: EEPROM emulation Fails after constant Read and Write operation.

Re: EEPROM emulation Fails after constant Read and Write operation.

Re: EEPROM emulation Fails after constant Read and Write operation.