About APatel.13

APatel.13 · 2023-07-10

Hello,I have interfaced the W5500 with the STM32L4S7VIT6 and working as per my requirement. However, my application needs to use the same application with the new MCU (STM32L4R5ZIT6). After porting the code to new MCU, application related to W5500 ge...

APatel.13 · 2022-04-15

Hi ST team and community,I'm here because I have some troubles on the process of initialization of multiple sensors VL53L1.I use the library of VL53L1.The process is the following :Shut down reset pin XSHUT of each sensorThen, in a loop (to setup my ...

APatel.13 · 2021-11-24

STM NUCLEO-L4R5ZI-P is used to interface the STEVAL-MKI182v2(ISM330DLC) .

APatel.13 · 2021-11-30

Hi TBomb.1,Thank you for the reply.I followed the same process as per below link from Github: https://github.com/STMicroelectronics/STMems_Standard_C_drivers/blob/master/lsm6dso_STdC/examples/lsm6dso_sensor_hub_lps22hh.cI tried to read device ID of L...

User statistics

User Activity

W5500 not working after changing/porting code for MCU from STM32L4S7 to STM32L4R5

Problem in changing address of VL53L1 sensors using "VL53L1_SetDeviceAddress" function.

After enabling the sensor hub I2C master bit in MASTER_CONFIG (1Ah) register of STEVAL-MKI182v2(ISM330DLC) I'm not able to read through ISM330DLC register for eg. 0x0f(WHO_AM_I).

Re: After enabling the sensor hub I2C master bit in MASTER_CONFIG (1Ah) register of STEVAL-MKI182v2(ISM330DLC) I'm not able to read through ISM330DLC register for eg. 0x0f(WHO_AM_I).