About Dhvanish Parekh

Dhvanish Parekh · 2018-08-01

We are planning to use 9DoF sensor LSM9DS1 with STM32L4 controller.We tried to find sensor library on web but not able to get one, can you pl provide us supported library including sensor fusion for STM controller?

Dhvanish Parekh · 2017-12-28

Posted on December 29, 2017 at 06:08Hi All,I am using the STM32L476 series controller in one of my projects. It is working as expected for all interfaces connected. But we are facing an issue of self-boot here.We have observed following things durin...

Dhvanish Parekh · 2018-01-03

Posted on January 04, 2018 at 05:47Hi All,Resolved issue by externally putting high value capacitor (10uF) on NRST pin.Thank you Clive & TJ for your kind help.While doing debugging as you suggested, we found that delay is not sufficient between VCC ...

Dhvanish Parekh · 2018-01-01

Posted on January 02, 2018 at 06:08Hi Clive,Kindly find below image of Schematic...Kindly note that I have externally connected GND through 10K resistor with BOOT0 pin for boot mode setup.

Dhvanish Parekh · 2018-01-01

Posted on January 02, 2018 at 05:45 , ,Hi Marsh,Thank you for your response!Can you share part ♯ and reset circuitry , you have used in your design?Do you see any hardware fault here to look into? We tried many options on reset pin but couldn't get...

User statistics

User Activity

Library along with sensor fusion for LSM9DS1

STM32 Controller need Hard Reset after power on to start Booting

Re: STM32 Controller need Hard Reset after power on to start Booting

Re: STM32 Controller need Hard Reset after power on to start Booting

Re: STM32 Controller need Hard Reset after power on to start Booting