About MAnil.1

MAnil.1 · 2022-01-06

Hi, I have been investigating a current leak in my circuit. I triangulated it to my IIS3DWB, when the accelerometer is not communicated through and all pins are pulled up by the MCU, I get a system current consumption of ~20uA (expected) But if I eve...

MAnil.1 · 2021-11-05

I have been characterizing the sub 200Hz characteristic of the IIS3DWB, and we are aware that it is somewhat an uncharted territory.But I was somewhat surprised by my observation when I compared a piezoelectric sensor attached to an IIS3DWB, vibrated...

MAnil.1 · 2022-06-24

In my case, shutting SPI peripheral down AND executing any code in the Errata worked. Shut SPI down?

MAnil.1 · 2022-01-13

Thanks Eleon,I have realized that my microcontroller has an errata about this issue. Today I was able to confirm it.

MAnil.1 · 2021-11-08

Eleon, thank you for your response. I realized that my measurement was far from ideal, therefore I will close this issue.

MAnil.1 · 2021-11-06

My follow up question: How can IIS3DWB estimate gravity as 1000 milli-g as the amplitude of the signal goes to zero at f=0Hz?

User statistics

User Activity

IIS3DWB consumes an excess of 1mA when it is communicated through SPI, only falling back with power cycling.

[Closed] Low frequency response of IIS3DWB

Re: IIS3DWB consumes an excess of 1mA when it is communicated through SPI, only falling back with power cycling.

Re: IIS3DWB consumes an excess of 1mA when it is communicated through SPI, only falling back with power cycling.

Re: [Closed] Low frequency response of IIS3DWB

Re: [Closed] Low frequency response of IIS3DWB