About RMala.2

RMala.2 · 2023-01-23

I am using X-CUBE-EEPROM software to emulate EEPROM in flash memory of the MCU.It is running on STM32G070RB. This MCU has endurance only 1 kcycle.We would like to store only a few variables (about 10) to the virtual eeprom. I expect that the main app...

RMala.2 · 2023-01-25

Hello @St�phaneM I have implemented a small routine which checks if there are dummy zeros at the end of the emulated location. And if the dummy zeros are detected it will skip step 8 during EE_Init().Is it OK to skip step 8 if there are dummy zeros ...

RMala.2 · 2023-01-23

Thank you @Peter BENSCH ,I didn't find this topic on community before. That's why I created a new topic.Thank you for the link to the answer.I will ask on that thread.Thank you and best regards,Roman.

RMala.2 · 2023-01-23

Hello @St�phaneM I understand how data recovery mechanism works and need to write zeros during EE_Init at the end of the emulated EEPROM.Is it possible to improve EE_Init routine with respect to the flash wearing of the emulated eeprom because of wr...

User statistics

User Activity

X-CUBE-EEPROM Is it possible to remove routine which writes 64bit zeros on every restart of the device? (It writes 64bits of 0 during EE_Init - due to data recovery mechanism).

Re: X-CUBE-EEPROM software package fills up emulated EEPROM with zeros on every call to EE_Init()

Re: X-CUBE-EEPROM Is it possible to remove routine which writes 64bit zeros on every restart of the device? (It writes 64bits of 0 during EE_Init - due to data recovery mechanism).

Re: X-CUBE-EEPROM software package fills up emulated EEPROM with zeros on every call to EE_Init()