I have a system containing a LSM9DS1 sampling AXL and Mag at 50Hz (gyro is disabled). When the LSM9DS1 is not attached (desoldered) our system (MCU only) draws about 2mA (10mV average over a 5 ohm resistor). This is constant and stable current of 2mA...

I am using the LSM9DS1 in our application with no problems normally. The gyro, axl and mag sensor all operating as requied. All written settings e.g. +/- range are set ok, and all registers read are giving the right outputs as device is moved around ...

Posted on December 13, 2017 at 08:36Hi. I would like to set a battery float voltage to 4.1v (to extend the life of the battery). Looking at the datasheet for the li-ion battery charger STBC02, it looks like this can be adjusted but 4.2v seems to be ...