About Pramod singh

Pramod singh · 2019-01-07

I have two peripheral where one works on 8-bit mode and the other on 16-bit mode. What could be the best possible solution for such situations?

Pramod singh · 2017-10-30

Posted on October 31, 2017 at 06:45STM32F0 command execution speed

Pramod singh · 2019-01-07

by the way my controller have FIFO, I just checked it out. So what do you suggest now to do

Pramod singh · 2019-01-07

Thank you for your reply.So basically you mean to say that, I will configure my master in 16 bit mode and use it for both the 8 and 16 bit slave if my controller supports FIFO. However the controller i'm using is stm32f4 series

Pramod singh · 2017-11-07

Posted on November 07, 2017 at 10:27 , ,Hii Jack,Thank You For your reply, Can you please guide me with the procedures of how to switch ,â€“mlong-calls , ,in specific compiler on ,System Workbench for STM so that i can use, ' , , ♯ define RAMFUNC __...

User statistics

User Activity

Is it a good idea to continuously reconfigure SPI form 8 bit to 16 bit or vice versa since the situation demands it.

Can you please find out and tell me, what is the no of clock cycles required to execute a single instruction in stm32f072. In our case at a frequency of 48 MHz the fastest speed i could achieve is 200n sec which is quite slow if we compare with the spee

Re: Is it a good idea to continuously reconfigure SPI form 8 bit to 16 bit or vice versa since the situation demands it.

Re: Is it a good idea to continuously reconfigure SPI form 8 bit to 16 bit or vice versa since the situation demands it.

Re: Can you please find out and tell me, what is the no of clock cycles required to execute a single instruction in stm32f072. In our case at a frequency of 48 MHz the fastest speed i could achieve is 200n sec which is quite slow if we compare with the spee