About AAnki.1

AAnki.1 · 2021-09-29

I have a project that transmit data on BLE and the old BLE that I was using has command for all there setting and those command were sent over the UART. I was hoping if I can use BlueNRG-2 and do all the settings via UART and stream my data over andr...

AAnki.1 · 2021-10-04

Hi @Sebastien DENOUAL ,Thanks for the suggestion. I was using "NRF connect" and it was not sending more then 20 bytes in text mode at a time. I tried with "BLE scanner" and it worked.I want one more thing to do If you can guide me would be great.I a...

AAnki.1 · 2021-09-30

Hi @Sebastien DENOUAL ,I tries to increase the byte length, Hear are the step that i followed.1) Changed Macro "CONTROLLER_DATA_LENGTH_EXTENSION_ENABLED" in stack_user_cfg.h file to 1.2) Changed Macro "DEFAULT_ATT_MTU = 64" but data length bluenrg1_...

AAnki.1 · 2021-09-29

Hi,Thank you so much. I will try these solutions and let you know how it goes.Thanks again for all your help.Regards,Aman

AAnki.1 · 2021-09-29

Hi @Sebastien DENOUAL Thank you for your reply. I already tried this on but I found few limitation in this.1) I am unable to receive more than 20Bytes in a message. Only receives a 20 bytes message from the phone.2) Does get any response on the UART...

User statistics

User Activity

How to integrate BlueNRG-2 in an existing application over UART?

Re: How to integrate BlueNRG-2 in an existing application over UART?

Re: How to integrate BlueNRG-2 in an existing application over UART?

Re: How to integrate BlueNRG-2 in an existing application over UART?

Re: How to integrate BlueNRG-2 in an existing application over UART?