About KUHAN JON

KUHAN JON · 2018-02-07

Posted on February 07, 2018 at 09:31Hi, everybody.I have a trouble in using STM32F103RET6 MCU.The problem is as follows.My board has one STM32F103RET6 as a controller and uses SPI2, UART2, 4 channels of ADC and some GPIOs.I downloaded the simple fir...

KUHAN JON · 2017-09-08

Posted on September 09, 2017 at 04:35Hello,I have a trouble using STM32F103VET6.I attached the reset and boot circuitary.i have assembled three boards and tested.Unfortunately, one of them was normal, but the others were not.The trouble is as follow...

KUHAN JON · 2018-02-08

Posted on February 08, 2018 at 14:11Thanks,Avatar.I will do as you said.

KUHAN JON · 2018-02-07

Posted on February 08, 2018 at 05:26Hi, Clive One.Thanks for your reply.Yes, I have a schematic.And i have not dirved any of the pins with 5V levels.I will attach the schematic.https://pan.baidu.com/s/1dHnjKNv

KUHAN JON · 2018-02-07

Posted on February 08, 2018 at 02:44Hi, thanks for your replies.Yes, AvaTar.When STM32F103RET6 is halted, the debugger loses contact to the CPU.And i add some information.When that MCU was halted, i desoldered all peripheral componenets such as capa...

KUHAN JON · 2017-09-10

Posted on September 11, 2017 at 03:55Hi,I have checked all power circuitary and not found any fault.But today I have seen a new warnig:Jlink warning:T-bit of XPSR is 0 but should be 1, changed to 1.Still did not solve the problem.Help me.Thanks,Jon.

KUHAN JON · 2017-09-10

Posted on September 11, 2017 at 02:27Thanks, Vangelis.I also have a doubt for the power circuit.Yes, i will check all power circuitary and reply the result.Thaks, Jon.

User statistics

User Activity

Non normal operation of STM32F103x

Jlink could not halt CPU during linking STM32F103VET6

Re: Non normal operation of STM32F103x

Re: Non normal operation of STM32F103x

Re: Non normal operation of STM32F103x

Re: Jlink could not halt CPU during linking STM32F103VET6

Re: Jlink could not halt CPU during linking STM32F103VET6