Alternatively single phase inverters will also work. Only power board with gate drivers and switch protection is needed. around 300Vdc link 5KW is sufficient.
Right that's what I was thinking, I can mount these boards vertically and perform forced air cooling. Should the cooling fan be facing the switch side or the back side of the pcb?Also, can you suggest any other board which has better thermal perform...
I have purchased two units of this board now. Is there any way we can mount heat sink at the back of the PCB ? There is some perforation on the board (inside the yellow square in the following image) would some non contact, forced air type cooling se...
I agree, I assumed that since the evaluation board is designed to drive all the DPAK and Power flat 8x8 devices, it may be capable of sustaining large current. The switch I am about to drive is rated at 30A peak and is a DPACK. Looking at the layou...
Hi Cristina, My apologies, there was a mistake in my previous question. I want to provide the PWM signals from an external micro-controller. I still want to use gate drivers available on the EVALSTDRIVE601. I checked the schematic of the board and ...
