About JMate.3

JMate.3 · 2022-07-04

I have created this easy project for the RAK3172 based on the LoRaWAN end node skeleton (myIoTopenTech/TiposDeDispositivos/TTNMAD_SOUND/STM32CUBEIDE/ttnmad_noise/) available on GITHUB.The program works properly joining to The Things Network using OTA...

JMate.3 · 2022-07-07

Something very odd.Tying the RX pin of USART2 to GND the power consumption is finally reduced to 1.5uA.I have the USART2 configured for only transmissión, but this does not reduce the consumption unless the RX pin is physically connected to GND.Anyon...

JMate.3 · 2022-07-04

Dear @AA.21 There is a seeedstudio solution that you could use as referencehttps://www.seeedstudio.com/LoRa-E5-CAN-FD-dev-kit-CANBUS-p-5398.html

JMate.3 · 2022-07-04

Thank you very much for answering @Uwe Bonnes I have checked this option so there shouldn't be floating pins.And also disabled debugger

User statistics

User Activity

STM32WLE5CC (RAK3172) LoRaWAN end node unable to reduce power below 150uA

Re: STM32WLE5CC (RAK3172) LoRaWAN end node unable to reduce power below 150uA

Re: Regarding STM32WLE5JC Micro Controller interfacing with CAN: How to interface CAN protocol to STM32WLE5JC board. which module is suitable for communicating from STM32WLE5JC to CAN Protocol.

Re: STM32WLE5CC (RAK3172) LoRaWAN end node unable to reduce power below 150uA