About KKuma.3

KKuma.3 · 2020-11-18

I am using Nucleo F303 RE and X-Nucleo - IHM08M1, MCSDK 5.4.4. 70 Watt motor with encoder.I am able to control the position of the motor with the provided application for a limited speed.Below are my questions,1 how can I tune the motor for a better ...

KKuma.3 · 2021-01-04

Yes I still have this issue.I am unable to find the solution for the issues.Regards,Kumar

KKuma.3 · 2020-11-18

Hello @Laurent Ca... "STM32 Motor Control"I have a similar requirement as stated in question above,You can find my hardware an software details below, Nucleo F303 RE and X-Nucleo - IHM08M1, MCSDK 5.4.4.70 Watt motor with encoder

KKuma.3 · 2020-10-22

@msingh You are right , I am using the STlink but on borad Jlink . refer this https://www.segger.com/products/debug-probes/j-link/models/other-j-links/st-link-on-board/

KKuma.3 · 2020-10-22

@msingh " STM32 Motor Control "I have used a similar set up as you have used, same controller and power board. The motor is also very similar , and it works perfectly fine with the position control application of 5.4.4.ST link could not provide live...

KKuma.3 · 2020-10-21

@msingh " STM32 Motor Control " it is strange , but try to clean the project and rebuild it. Have you selected the correct binary to flash ? Have you changed any optimization settings or compiler flags ? Are you trying using the atollic ide or STM32...

User statistics

User Activity

Position control , "STM32 Motor Control"

Re: Position control , "STM32 Motor Control"

Re: Does STEVAL-SPIN32 allow direct torque/current control (no speed) on a BLDC motor?

Re: position control randomly stopped working

Re: position control randomly stopped working

Re: ADC converstion doesn't complete, if (RCM_GetUserConvState() == RCM_USERCONV_EOC) is never true.