About Bertrand DENIS

Bertrand DENIS · 2013-05-14

Posted on May 14, 2013 at 19:37The http://www.st.com/pr-stm32f401 is the entry-level microcontroller in STMicroelectronics� high-performance http://www.st.com/pr-stm32f4 featuring the ARM� Cortex�-M4 32-bit/DSP core. While running at lower frequency...

Bertrand DENIS · 2022-01-13

Hello,There is a high probability that some IOs are not correctly settled. I saw you set all IOs as pull-down but if there is an external pull-up you will see a power consumption.Check the schematics and set each IO accordingly.Bertrand

Bertrand DENIS · 2020-12-01

Hello,The STM32L4 and STM32L4+ family is fully in production and no issue to deliver all the parts. Have you placed an order ? The distributors put more on the shelf the 85°C version ("6" more generic) rather than the 125°C ("3"). Thanks,Bertrand

Bertrand DENIS · 2018-03-15

Posted on March 15, 2018 at 22:16One solution could be to cycle a part of the Flash well above 10k until the ECC interrupt triggers.

Bertrand DENIS · 2018-02-07

Posted on February 07, 2018 at 22:54Below V_IL max you are sure that it will be seen as a 0, above V_IH min it is a 1. Between these two values it is grey area.

Bertrand DENIS · 2017-09-20

Posted on September 20, 2017 at 17:18Hello,Thanks for your interest on our future STM32 products. It will be announced and available mid of November.If you need to know more in between I suggest you to contact your STMicroelectronics contact or dist...

User statistics

User Activity

STM32F401 sampling now

Re: Nucleo - STM32L412RB-P: How to measure IDD only through STM32 Microcontroller?

Re: Hi, STM32L4S5QII3P has been out of stock for a while now, is this just now or do you see this part to be out for long term? -Mark

Re: STM32L476 - how can I create an ECC error to test my error handling

Re: What's threshold voltage for external interrupt?

Re: STM32L4+ (STM32L4 Plus) seris