About Giorgio Cancelli

Giorgio Cancelli · 2019-10-03

HI,I've problems on the temperature detected by the LSM9DS1. I used the "Unico" software to configure the Acc/Gyro and the Magnetometer, in particular I used the "Easy configuration button".I read the temperature (Unico page Acc/Gyro Registers) from ...

Giorgio Cancelli · 2017-04-21

Posted on April 21, 2017 at 17:25I tried to read the default I2C password (address 2304 with E2 = 1) that should be 0000 0000h whilst I found FFFF FFFFh. For verification I also tried to read the other System parameter sector and the returned values...

Giorgio Cancelli · 2019-10-04

Hi,forget the previous message...now I really got!!!BR,Giorgio

Giorgio Cancelli · 2019-10-04

You're right and I understood your explanations. The point is that the sensor (EVAL BOARD) is in office as when it was detecting 25°C.I configured the sensor with Unico as all other times.Any clue?

Giorgio Cancelli · 2019-10-04

Ciao Eleon,thank you very much! Really appreciated.I'm experiencing another kind of problem at the moment. Same steps I mentioned above but the temperature registers are now:OUT_TEMP_L: 0xD0OUT_TEMP_H: always 0xFFIt seems the device is not configured...

User statistics

User Activity

LSM9DS1 Temperature

M24LR04E-R memory initial state.

Re: LSM9DS1 Temperature

Re: LSM9DS1 Temperature

Re: LSM9DS1 Temperature