About FNtin.1

FNtin.1 · 2022-06-14

LORA DATASHEETThe default settings for the UART interface are 57600 bps, 8 bits, no parity, 1 Stop bit,no flow control. The baud rate can be changed by triggering the auto-baud detectionsequence of the module. To do this, the host system needs to tra...

FNtin.1 · 2022-06-18

Sorry for the late reply,I've borrowed a logic analyser and found that when i call Hal_lin_break function generates a LOW signal for about 100us.That figures out that lora module wont wakes up.It needs at least 160us,or 200us to be sure.So i think t...

FNtin.1 · 2022-06-14

with which way?i cannot write gpio.writepin(low) as its not a general purpose output pinSending a coumple 00s seems not working

FNtin.1 · 2022-06-14

Sorry,yes it is mentioned by Microchip so i cant doubt about it.

FNtin.1 · 2022-06-14

Thanks for fast reply,To be clear sometimes wakesup. I only tried via hal library and LIN mode.I cannot dig into uart registers.As RX pin is not used as output pin i think i cant "gpio.writepinLOW" for couple of time.SO,Could you think an implementat...

User statistics

User Activity

Cannot send break condition via uart.I have a nucleo board 32l422 and i connected lora rn2483. I can communicate with module but when set this to sleep i cannot wake up module.I tried HAL_LINSendBreak with no success.

Re: Cannot send break condition via uart.I have a nucleo board 32l422 and i connected lora rn2483. I can communicate with module but when set this to sleep i cannot wake up module.I tried HAL_LINSendBreak with no success.

Re: Cannot send break condition via uart.I have a nucleo board 32l422 and i connected lora rn2483. I can communicate with module but when set this to sleep i cannot wake up module.I tried HAL_LINSendBreak with no success.

Re: Cannot send break condition via uart.I have a nucleo board 32l422 and i connected lora rn2483. I can communicate with module but when set this to sleep i cannot wake up module.I tried HAL_LINSendBreak with no success.

Re: Cannot send break condition via uart.I have a nucleo board 32l422 and i connected lora rn2483. I can communicate with module but when set this to sleep i cannot wake up module.I tried HAL_LINSendBreak with no success.