About jorgazam

jorgazam · 2022-09-14

Hi,I'm currently working to start the FUOTA on a STM32WB, so I've spent several time following the Application Note AN5247 and watching the MOOC - STM32WB Firmware Update Over the Air (FUOTA) videos that explain how to run the OTA on a P-NUCLEO-WB55 ...

jorgazam · 2022-04-28

Hi, my name is Jorge.I'm currently working with an STM32WB5MMG, which has Bluetooth LE 5.2 connectivity. In the current version of the project, it's working with two Bosch sensors. The BMI088 with accelerometer and gyroscope, and the BMM150 with a ma...

jorgazam · 2022-05-18

Hi, I realized that the sensitive GPIOs doesn't have the corresponding capacitors thanks to your answer, however, I use these pins only for an external memory that I'm not using at this moment, so I'm not using them for the communication with any of ...

jorgazam · 2022-05-06

Yes, the clock configuration is set like this:void SystemClock_Config(void){ RCC_OscInitTypeDef RCC_OscInitStruct = {0}; RCC_ClkInitTypeDef RCC_ClkInitStruct = {0}; /** Configure LSE Drive Capability */ HAL_PWR_EnableBkUpAccess(); __HAL_RCC_LSEDRIVE_...

jorgazam · 2022-05-04

I verified that using only the BMM150 sensor the disconnection also happens. The main clock of the MCU is set to 64MHz, but in SPI it is prescaled to work at 8 MHz.After disconnecting from the mobile device, it takes a few seconds (sometimes more tha...

User statistics

User Activity

Launch FUOTA in custom application for a STM32WB5MMG

BMM150 causing problems with the BLE communication

Re: BMM150 causing problems with the BLE communication

Re: BMM150 causing problems with the BLE communication

Re: BMM150 causing problems with the BLE communication