About Tetrastruct

Tetrastruct · 2022-07-25

I 'v been driven creasy since some days, cause I did not find a way to switch off the PWMs at one channel of timer 1 ( CH1 an CH1N ie.) in order to use these pins controlled by normal GPIO commands on the fly,while the other channels shoud work aga...

Tetrastruct · 2022-05-24

Tetrastruct · 2022-05-24

Which chip is inside and how can I launch the software, STcube IDE always permitt launching with the note: no ST device found.

Tetrastruct · 2022-07-28

sorry wrong typed ST32F405.Hello Jan, Thanks a lot for your answer, Yes you are right this works, I tried it and imediately it works, indepedent from changing other registers and alternete functions and so on. Thank you very much.I tried this at the ...

Tetrastruct · 2022-07-26

Tkank you for your comment.Reinhard

Tetrastruct · 2022-07-26

Yes I will try that, May be I have to switch it to AF0(System) to switch the port back to ODR.

Tetrastruct · 2022-07-26

STM32F04

Tetrastruct · 2022-05-24

I tried also with TIM4@STM32F405RTG6 . It shows the same behaivior. The CNT Register takes the value but the counter stops imediately and did not run again. Setting the CEN bit to 1 dont bring success.What I have to be care for to restart the counte...

User statistics

User Activity

Remove alternate function of single TIM1 Channel outputs and get the control over these pins by GPIO on the fly and take the alternate function back on the fly.

rg. ST32F405 timer 8 does not count again after stopping it and writing the CNT Register on the fly. Alfter enabeling by software (TIM8->CR1 ||= 0x0001;) it stayt still and does not count again.

I have chips in a 48 LQFP case with the sign on top of ST32F103C8T6. I can connect them with ST-Link properly and he recognices an device ID: 0f 0x414. 256kByte Flash ST3210xx High density device. I'm not able to handle these devices in CSTcube IDE

Re: Remove alternate function of single TIM1 Channel outputs and get the control over these pins by GPIO on the fly and take the alternate function back on the fly.

Re: Remove alternate function of single TIM1 Channel outputs and get the control over these pins by GPIO on the fly and take the alternate function back on the fly.

Re: Remove alternate function of single TIM1 Channel outputs and get the control over these pins by GPIO on the fly and take the alternate function back on the fly.

Re: Remove alternate function of single TIM1 Channel outputs and get the control over these pins by GPIO on the fly and take the alternate function back on the fly.

Re: rg. ST32F405 timer 8 does not count again after stopping it and writing the CNT Register on the fly. Alfter enabeling by software (TIM8->CR1 ||= 0x0001;) it stayt still and does not count again.