Posted on December 08, 2012 at 20:38The original post was too long to process during our migration. Please click on the attachment to read the original post.
Posted on December 04, 2012 at 21:15I'm struggling a little bit getting the CAN up and running on my board. The board is one that we've designed using an STM32F107. It uses a 25 MHz crystal so the timing should be just like the demo boards. I'm w...
Posted on December 08, 2012 at 17:16So, I'm pretty sure I have found the issue with this remap. I started commenting out other features in my firmware until the CAN2 started working and then added code back in until it broke again. What I found was...
Posted on December 06, 2012 at 15:53Dear CRT, Thanks for the response. There is no external pull-up between the uC and the CAN chip (SN65HVD1040). PB5 and PB6 run directly to TXD and RXD on the CAN chip. To prove to ourselves that we didn't have a...
