Posted on February 23, 2014 at 19:14Hello,I use TIM1 to generate a clock-signal at the gpio-output-pin TIM1_CH1. This signal will be generated until a rising edge is detected at TIM_ETR (gpio-input). So the output-signal will be immediately pulled d...

Posted on November 02, 2012 at 23:24 Hello, I use this example code below to get an ISR from GPIO PA0. My hardware is the STM32L152 at board STM32L152D-EVAL. ( http://www.st.com/internet/evalboard/product/2517jsp) So I have only one ta...