About singamicro

singamicro · 2011-11-10

Posted on November 10, 2011 at 11:56Can anyone explain why the segments of the microcontroller are connected to the LCD segments in such a way ? In particular, why are Segment17(chip) connected to Segment12(LCD) and Segment16(chip) connected to Seg...

singamicro · 2011-11-22

Posted on November 23, 2011 at 05:48Edit stm8s_conf.h to comment out #define USE_FULL_ASSERT (1) which is about 23 lines from the bottom. I had a same or similar problem with STVD and solved it with the above. I had since then use IAR. http://s...

singamicro · 2011-11-22

Posted on November 22, 2011 at 14:14My understanding of the HD44780 is that it may be either in the 4-bit mode or in the 8-bit mode when powered up. Hence, it is usually necessary to send 0x38 three times to initialise it properly. By the way, it s...

singamicro · 2011-11-10

Posted on November 10, 2011 at 11:48Please see if this is useful.http://singamicro-63-stm32l152-k1.blogspot.com/p/lcd-page-32.html Regards.

singamicro · 2011-10-22

Posted on October 22, 2011 at 11:59When you plug the board to the PC, it may appear like a disk. Try follow some of these: http://singamicro-50-stm32f100rb.blogspot.com/

singamicro · 2011-10-22

Posted on October 22, 2011 at 11:52Please read 1200rata's posting on disabled swd debuging in this forum. Try: [DEAD LINK /public/STe2ecommunities/mcu/Lists/STM32VLDiscovery/Flat.aspx?RootFolder=/public/STe2ecommunities/mcu/Lists/STM32VLDiscovery/di...

User statistics

User Activity

LCD on Board

Re: STVD First Project help

Re: LCD init problem

Re: STM32F4 16x2 lcd driver

Re: impossible to using.

Re: Failed to read CPUID for Cortex device. ST-Link problems.