About pritz1

pritz1 · 2011-10-11

Posted on October 11, 2011 at 19:55Hello,I am trying to integrate the SysTick example into some code that I am developing and I can't seem to get it to work. I even tried just pulling the code from the example and loading it onto the microcontrolle...

pritz1 · 2011-06-07

Posted on June 08, 2011 at 02:31Hello,I am a student and I am starting my final project a little early, and I am glad I did because I am really confused! I am making a guitar-playing robot that I am going to drive off of this handy-dandy microcontr...

pritz1 · 2011-10-11

Posted on October 12, 2011 at 00:28Nevermind - I figured it out. I had to put:TimingDelay_Decrement(void);in the Systick handler:void SysTick_Handler(void)in the file stm32f10x_it.cHope this helps other people.

pritz1 · 2011-09-30

Posted on September 30, 2011 at 18:04Thank you very much. I appreciate it.

pritz1 · 2011-09-27

Posted on September 27, 2011 at 23:21I tried to alter the code to use the TIM3 to output a 200 Hz signal and to use the TIM2 to output a 220 Hz signal. It doesn't work so well. The TIM3-200Hz signal works fine but the TIM2-220Hz signal does not. ...

pritz1 · 2011-09-22

Posted on September 22, 2011 at 20:26Nice. That wasn't too hard for me to figure out, although I ended up just commenting out RCC_Config() because it said the function did not exist...Is there an easy way to output two square waves of different fre...

pritz1 · 2011-09-19

Posted on September 19, 2011 at 21:27Will this code also work for the STM32 Discovery board? What is TIM3-CH2?

User statistics

User Activity

Systick not working???

GPIO driving outside logic

Re: Systick not working???

Re: Creating a square wave

Re: Creating a square wave

Re: Creating a square wave

Re: Creating a square wave