About marcot

marcot · 2017-03-19

Posted on March 19, 2017 at 21:25I am looking for a graphic co-processor chip or PCB to add to my embedded processor boards used with industrial equipment.My boards presently use the STM32F4xx micro-controller which is a little slow for graphics pro...

marcot · 2011-05-15

Posted on May 15, 2011 at 13:34STM32 schematic symbols and PCB footprint for Altium CAD

marcot · 2011-05-13

Posted on May 13, 2011 at 20:22STM32F217 Pinout

marcot · 2017-03-22

Posted on March 22, 2017 at 10:39Thank you Jan for your answer but it is not acceptable to add a PC to this type of embedded industrial controller. I need a medium volume, rugged solution that will work for the next twenty years. This is not a one...

marcot · 2011-05-17

Posted on May 17, 2011 at 14:35Thank you. This is a good start but I was hoping for ST to keep this info up to date.

marcot · 2011-05-17

Posted on May 17, 2011 at 14:34Unlike almost everybody else, ST doesn't have a register per channel. You either read after each conversion or use the DMA. Extract from the manual:Analog-to-digital converter (ADC) RM0033 216/1317 Doc ID 15403 Rev 3...

marcot · 2011-05-17

Posted on May 17, 2011 at 14:34I understand that the analog pins are special but at least bring enough out to make it useful and don't use the same pins for the three A/D converters. This makes them mutually exclusive as far as the channel count is...

marcot · 2011-05-17

Posted on May 17, 2011 at 14:34What breaks my heart is that even with the 176 pins case, many functions are mutually exclusive. It is a shame that the design team worked so hard a producing these marvelous functions just to have their use so limited...

User statistics

User Activity

I looking for a graphic co-processor chip or PCB to add to my embedded STM32F4xx board

STM32 schematic symbols and PCB footprint for Altium CAD

STM32F217 Pinout

Re: I looking for a graphic co-processor chip or PCB to add to my embedded STM32F4xx board

Re: STM32 schematic symbols and PCB footprint for Altium CAD

Re: Detection of different ADC channel from same ADC1?

Re: STM32F217 Pinout

Re: STM32F217 Pinout