About wolfram

wolfram · 2011-04-05

Posted on April 05, 2011 at 11:30Hello, when i try using the STM32 Discovery board (STM32F100) with Keil uVision (V4.20.03.0, Target DLL: STLink\ST-LINKIII-KEIL.dll V1.5.6), when i try to debug or flash there always pops up this error:''Failure load...

wolfram · 2011-05-26

Posted on May 26, 2011 at 17:03Hi Ibtissem, the ST-LINK V2 driver did the trick, thanks! Wolfram

wolfram · 2011-05-03

Posted on May 03, 2011 at 10:08Hello JR, thanks for the new library, but the problem remains the same. Wolfram

wolfram · 2011-04-19

Posted on April 19, 2011 at 16:28 @skocir.simon: Unfortunately, no :( @pantani: I installed the ST-Link Utility, but here an error box pops up and says: ''Unknown target connected'' I dunno.. I tried the IAR-IDE, and this just works...

wolfram · 2011-04-07

Posted on April 07, 2011 at 13:14Update: i found out that the ST-LinkUpgrade.exe shows a similar problem. When starting it, there is first this error message: ''Cant load library: ST-Link/V2 USB driver is missing'' and then after pressing ''Device c...

User statistics

User Activity

Problem with Keil uVision 4: ''Failure loading STLinkUSBDriver.dll''

Re: Problem with Keil uVision 4: ''Failure loading STLinkUSBDriver.dll''

Re: Problem with Keil uVision 4: ''Failure loading STLinkUSBDriver.dll''

Re: Problem with Keil uVision 4: ''Failure loading STLinkUSBDriver.dll''

Re: Problem with Keil uVision 4: ''Failure loading STLinkUSBDriver.dll''