About weedoug18

weedoug18 · 2011-05-20

Posted on May 20, 2011 at 13:52Hello, I m trying to use the stm32vldiscovery board as a stand alone st-link programer, to program a stm32f207 microcontroller, through stm3220f board. As I plug the two board one to the other, before to start the debu...

weedoug18 · 2011-04-05

Posted on April 05, 2011 at 19:07Bootloader flash programming stm3220f-EVAL

weedoug18 · 2011-05-26

Posted on May 26, 2011 at 16:29 Hello, Thanks for the help. I actually use the V2 version, the jumpers and wire are OK I think because I could program the chip without any problem using ST-Link Utility. I have installed the V2 version on uVision4 an...

weedoug18 · 2011-05-17

Posted on May 17, 2011 at 14:30 Hello! No matter, I flash it through my stm32 discovery board at least.. bye

weedoug18 · 2011-05-17

Posted on May 17, 2011 at 14:12 HI, I m stuck at the same step too, trying to change the baudrate doesn't help, neither that the command line part. I m using a stm32f2 series microcontroller. Do you have fixed your problem? Thanks

weedoug18 · 2011-05-17

Posted on May 17, 2011 at 14:06 Ok perfect, thanks for the support!

weedoug18 · 2011-05-17

Posted on May 17, 2011 at 14:06 Hi clive Thanks a lot, sorry for the delay. But it works fine. The boot pin is only checked at the initialisation of the programm to load the program in the flash or the RAM right? Thanks a lot Best regards

User statistics

User Activity

STM32vl discovery as st-link

Bootloader flash programming stm3220f-EVAL

Re: STM32vl discovery as st-link

Re: Bootloader flash programming stm3220f-EVAL

Re: STM32F103RB Flash Loader V2.2 Problem

Re: ST-Link Error: Failed to reset ST-Link device

Re: ST-Link Error: Failed to reset ST-Link device