About cb

cb · 2011-08-02

Posted on August 02, 2011 at 12:05Hi, we have a question that is only partly related to the STM32, but unfortunately we didn't get a response to our online request and there is a STM32 next to the STHDLS101A ;) Concerning the HDMI level shifter STHD...

cb · 2011-05-17

Posted on May 17, 2011 at 13:59Ok, I got it: In the start-up code, I used the wrong name for the interrupt handler, USB_LP_CAN1_RX0_IRQHandler instead of CAN1_RX0_IRQHandler. Now it works fine.

cb · 2011-05-17

Posted on May 17, 2011 at 13:59Hi, today, I had some time to determine the problems with the two CAN interfaces and out STM32F105 boards. The problem is not CAN2, but CAN1. If the interrupt CAN1_RX0_IRQn is enabled, the microcontroller hangs up some...

cb · 2011-05-17

Posted on May 17, 2011 at 13:59Hi, > I'm not a CAN guy, but the classic hang up issue with interrupts on the STM32 > (M3/NVIC) is that if you fail to clear all the pending interrupts it will tail-chain back > into your IRQ code in a tight circle, a...

cb · 2011-05-17

Posted on May 17, 2011 at 13:59Hi Hitesh, well, I was told to enable the CAN1 clock, too, even when I only use CAN2. This is because of the fact that CAN2 is a slave module of the CAN1 module. Give it a try and let me know. If it works, I will use y...

cb · 2011-05-17

Posted on May 17, 2011 at 13:59Hi Hitesh, can you post your code? I would like to figure out any differences. What's the date code of your controllers? We are using controllers with the code 926, so rather old ones, but new ones are actually not ava...

User statistics

User Activity

STHDLS101A: Exposed Pad Connection

Re: use dual CAN on stm32f105,can2 can not send

Re: use dual CAN on stm32f105,can2 can not send

Re: use dual CAN on stm32f105,can2 can not send

Re: use dual CAN on stm32f105,can2 can not send

Re: use dual CAN on stm32f105,can2 can not send