Posted on May 17, 2011 at 13:03Hi I'm new to the STM32 .As is see the ouput ports are 16 bit wide. I need to address memory with 20 address lines .I don't want to use the memory interface some parts have .Is it possible to write a single 32 bit word...
Posted on May 17, 2011 at 13:03Thanks jj Is a cpld combination cheaper than a FMSC equiped device ?. What CPLD have you used?. I have one LCD but ,although 8080 bus compliant, uses 18 bits single cycle write and two cycles 16 bit mode (plus shifts)....
Posted on May 17, 2011 at 12:45Dear Russ1 Nordic will give you +7-8 dBm output power . Now you have to design your link at -60 dBm. Where you are loosing is the fact that nordic needs 1MHZ BW since its designed for 1 mbit communication so that dicta...
Posted on May 17, 2011 at 12:45Ok Russ1 I will give you some directions since the subject of RF and transmission requires a lot of expertise and some consider it ''black art''. Separate first of all two worlds and one is the radio part and the secon...
Posted on May 17, 2011 at 12:45Hi I'm quite experienced with radios short-long range and serial communications. If you are still looking for solutions contact me .
