Posted on May 17, 2011 at 13:24why are you re initializing the timer again with these lines you have already done that one time you dont need to define which one is correct and put everything before you enable the counter not after that. Other than ...
Posted on May 17, 2011 at 13:22thanks for your reply but still my I am not able to receive CAN packet with ID 5 I been using CAN interrupt and canopen from last one year and I am getting interrupt for every CAN packets but when I use filtering I do...
Posted on May 17, 2011 at 13:22can anybody help me in setting up the message filtering for CAN I want to receive CAN message which are meant for me I have running slave devices and I want to get interrupted when I receive the message for that partic...
Posted on May 17, 2011 at 13:17I am also using FW STD preipheral ver 3.0. CAN is working fine. Just check your correct baud rate because in loopback mode Baud rate does not make any difference. Also check your CAN clock, AFIO clock and remapping pin...
Posted on May 17, 2011 at 13:15Did anybody use CAN controller acceptance filtering. please give me some example code, not able to understand it. thanks.
