Posted on October 03, 2007 at 09:13Hello Sir, Thank you sir for your reply. If want to change application from the ST10F269 to the ST10F276 and use only IFLASH , Is posible? Do I need to initialize any other registers? Could please help me on this...
Posted on October 01, 2007 at 08:03Hello Sir, Thank you sir for your reply. I would like to get example of demo code that send output Thur RS232 do any one have that kind of code for me to study how it work ? Thank you very much Best regards, sagai....
Posted on September 25, 2007 at 06:06Thank you sir for your reply . I did open st10 flasher - enter the bootstrap loader mode - reset the st10 - click the erase flash button command - click on the Program - Verify button command Do you have any...
Posted on September 20, 2007 at 08:51 I did remove jumper J1 on eva269 board for stop using external ram and the result still same as my own design the problem was the values that show in hyper terminal is incorrect only show ............. my st10 ...
Posted on September 20, 2007 at 00:12 Thank you sir for your reply . My point of quation is can i get st10 to work without using EXTERNAL RAM and EXTERNAL FLASH ? Base on st10 desing from eva269 board of FS Forth to answer you qoution about hardware...
