Posted on May 09, 2006 at 12:07That's fine - I didn't realise you were all one and the same group of guys!! I'll work through my contact now, but hopefully the information was useful to you anyway
Posted on May 09, 2006 at 10:32Hi, I am working on a dual-ST10F269 system (although the dual-ness can be ignored from hereon in) that is usually programmed by flicking a switch into a specific position which pulls P0.4 low and makes the ST10 process...
Posted on April 19, 2006 at 07:06Thanks Neila. Yes you are right about what I'm doing with the BSL. My BSL now explicitly sets XRAM1EN in XPERCON reg, then also sets XPEN but it has had no effect. These are the default values anyway aren't they? Whe...
Posted on April 12, 2006 at 14:17I'm writing a BSL for an ST10F269 to talk to the ST10 Flasher supplied by ST. The idea is that I handle the start of the world and then hand over to the ST10 Flasher's monitor program for the rest of normal operation...
Posted on April 05, 2006 at 06:22 Hi, I'm currently working on a BSL for an ST10 processor. The basic idea is that normally we would flick a switch on the board to enable BSL mode, download the image using the ST10 Flasher tool, and then flic...