About Cindy_GE

Cindy_GE · 2021-11-01

1. Reboot the board, and hit any key to stop in the U-boot shell Board $> reboot [...] Hit any key to stop autoboot: 0 STM32MP> 2. Connect a USB cable between the host machine and the board via the USB OTG ports, in the U-Boot shell, call the USB ma...

Cindy_GE · 2021-08-22

For this error is link to you deleted u-boot-stm32mp177d-dk1-trusted.stm32, please keep it, because it is needed by 0x03 partition.

Cindy_GE · 2021-08-20

what are you using to flash the board? and how do you compile the u-boot image, with CubeIDE?

Cindy_GE · 2021-08-17

First you need to check the starter package version you used, if you use v2.x or v1.x, you should replace <starter_package_patch>/.../bootloader/u-boot-stm32mp177x-dkx-trusted.stm32 with u-boot.stm32 (generated), but looks, you don't have it in you l...

Cindy_GE · 2021-08-15

There should be one "\" ate the end of "boot_m4_mmc0=if ext4load mmc 0:4 ${m4fw_addr} ${m4fw_name} ; then run boot_m4fw; fi;\0" \

User statistics

User Activity

Re: there's a way to update a microSD partition without touch the boot mode switch?

Re: Hi,i am a beginner in MPU development. I have created cortex-M4 firmware project using stm32cubeide , but how can i start my firmware at the time of bootup?

Re: Hi,i am a beginner in MPU development. I have created cortex-M4 firmware project using stm32cubeide , but how can i start my firmware at the time of bootup?

Re: Hi,i am a beginner in MPU development. I have created cortex-M4 firmware project using stm32cubeide , but how can i start my firmware at the time of bootup?

Re: Hi,i am a beginner in MPU development. I have created cortex-M4 firmware project using stm32cubeide , but how can i start my firmware at the time of bootup?