Posted on August 08, 2006 at 13:06Found the problem. Hope this helps others with similar problems. Problem was rst was being held low too long. The reset supervisor was looking for a low condition then it held it low for up to 300ms.
Posted on August 04, 2006 at 12:31I have a similar problem, but the demo board works fine but our prototype boards do not. Everything seems to be correct with the reset timing, all signal lines are the same as demo board and voltages and pull-ups an...
Posted on September 15, 2005 at 17:05I've read the other postings about the JTAG reset circuit but they don't answer if the circuit is even necessary. If the jumper is not in place in the eval board, the circuit is doing nothing. Why would I need to...
Posted on May 06, 2005 at 19:05We are going to use the STR71x and I would like to use the M25P serial flash, but I do not see a way to use a serial flash for code storage and execute from the flash. Is there a way to execute code and boot from seria...
