Posted on September 16, 2004 at 22:26Hello Peterwrigley, looks like i have found the problem. I have been advised that some computers use a 3.3v lpt and some use a 5v lpt. the inDART kit will only work on 5v lpt and both of my computers use 3.3v lpt...
Posted on September 16, 2004 at 02:35Hello Peterwrigley, The development tool i'm using is the inDART-ST72C-SK. I have had a look for the Frequency command and have also been told that this command is not available with this development tool.
Posted on September 14, 2004 at 21:10Hello peterwrigley, The instruction frequency that you mention does not apper in my datablaze. my driver version is v.1.17. Hello Luca_Defend, I'm using the ISP cable to power the inDART board with a voltage of 4...
Posted on September 13, 2004 at 20:46i have made sure the option bytes are correct and tried changing the reset rise time but it still doesn't work. but it will work ok on the laptop i have also tried different parallel port modes on my comuter but ...
Posted on September 13, 2004 at 02:19hello, I'm need help with the the following error error:gdi-error:communication error between the instrument and the target device. I don't have this problem on a mates laptop running xp pro but on my desktop run...
