About Valerio1

Valerio1 · 2017-04-28

Posted on April 29, 2017 at 01:54I made a board with an STM32F405RGT6V, I follow the 'getting started design guide', the datasheet and the Reference Manual plus other documentations for ADC accuracy and so on.So now I have my board with VDDA paired ...

Valerio1 · 2017-04-30

Posted on May 01, 2017 at 02:02Soo, debugger in CoIDE under windows 7 is better configured and it works!The board works, breakpoints works, NUCLEO works!FantasticIf someone could explain this openocd behaviour, finally it is the base of SystemWorkbe...

Valerio1 · 2017-04-30

Posted on April 30, 2017 at 18:54This is an interesting info, without the VDD connection all have the same behaviour, only GPIO code run, enabling other peripherals break the execution and stuck at reset values.Openocd find too low voltage

Valerio1 · 2017-04-30

155793CGIL4

Valerio1 · 2017-04-29

Posted on April 29, 2017 at 10:49Hi Clive, thanks for the quick reply.My STLINKV2-1 is a Nucleo board without the jumpers CN2 and with out the nucleo board attached, I broken the programmer from the board, also I desoldered the 0 Ohm resistors: NRST...

User statistics

User Activity

stlink_usb.c:773 stlink_usb_init_mode(): target voltage may be too low for reliable debugging

Re: stlink_usb.c:773 stlink_usb_init_mode(): target voltage may be too low for reliable debugging

Re: stlink_usb.c:773 stlink_usb_init_mode(): target voltage may be too low for reliable debugging

Re: stlink_usb.c:773 stlink_usb_init_mode(): target voltage may be too low for reliable debugging

Re: stlink_usb.c:773 stlink_usb_init_mode(): target voltage may be too low for reliable debugging