Hi all,I am developing an application on the STM32WLE5CC based on the existing Nulceo boards for the JC part. First, the BoM provided for the JC reference is completely incorrect, it doesn't match the RF network design note, it's own schematic or the...

I'm currently developing a project that will see a high number of MCUs connected in the end application so low power consumption is critical. I was aware there will be some initial high power consumption when first powered up however the MCU takes ~3...

I don't want to use the provided SW library for the STUSB1602, it's far too complicated for my application and I'm using a different MCU.The datasheet only has a register overview, the software doesn't seem to have any info and there aren't additiona...

Hi all,I'm trying to work with the LIS3DSH but i'm not getting any output data.I have verified the SPI is working, I can write to and read back numbers from the registers so I know they are getting set correctly. I'm using the initialisation code bel...

Hi all,Just wondered if anyone had a similar experience with this. Currently i'm storing a devices current state and settings in the EEPROM. This information is accessed and updated at a high frequency during a part of the program. I have experienced...