About mocnikg

mocnikg · 2016-05-24

Posted on May 24, 2016 at 19:34 Hello, I would like programming SPI communication betwen master and slave. With STM32CubeMX generated code for Keil with config for my board. In Cube activated SPI1 and HalfDuplex mode, other leave default....

mocnikg · 2016-03-19

Posted on March 19, 2016 at 20:50Hello, I am newbie in STM microcotrollers family. Other HelloWorld project work's fine. Now I have new project, I would like show data from memory on microcontroller on my PC. I created project in STMCubeMX then buil...

mocnikg · 2016-05-25

Posted on May 25, 2016 at 19:43Thank's for help, I didn't saw this file, now I delete my Initialization in main.c and call function HAL_SPI_MspInit(&hspi1);, abowe MX_GPIO_Init(); and MX_SPI1_Init(); in while (1) loop would like send data with HA...

mocnikg · 2016-03-29

Posted on March 29, 2016 at 16:54Is there a way to access the memory (over usb) on a SD card if it is connected to the MCU?

mocnikg · 2016-03-23

Posted on March 23, 2016 at 19:18I ran an example, which was generated in STM32Cube. I connected the USB with the PA11 and PA12. I set the jumper on E5V and the device showed on my PC (Raw file system). I can see the memory map with HEX Editor.I wis...

mocnikg · 2016-03-23

Posted on March 23, 2016 at 15:34I wish to access my data on the flash. How can I do it? Can I create a txt file on MCU and then show this file on my PC, over USB.

User statistics

User Activity

Nucleo 64 - L053R8 SPI

STM32L053R8 as USB mass storage

Re: Nucleo 64 - L053R8 SPI

Re: STM32L053R8 as USB mass storage

Re: STM32L053R8 as USB mass storage

Re: STM32L053R8 as USB mass storage