ST8 STVD simulator help needed

kumaresh · ‎2015-05-27

Posted on May 27, 2015 at 11:21

hello, i am trying to understand how plotter works on STVD simulator. when i go in simulation mode and Select 'View>I/O Stimulation' , i dont see any pin name like PA1 or PD1 etc and i can only see RESET, IRQ1 to IRQ29. what should i do to see pin wise simulation in STVD.

thanks in advance

#stvd #stm8 #simulation

Ian Legg · ‎2015-05-27

Posted on May 27, 2015 at 13:38

Hello,

I think you will find that the simulator isn't of much use because it hasn't been updated for the STM8. Apparently it works fine with the ST7 (the STM8 replaced this version). It would be helpful if ST updated their simulator!

Thanks,

Ian