Posted on October 06, 2011 at 11:06Hello, I think there is an error in v2.3.0 of this Library. The MKEY_CH2_MASK and MKEY_CH3_MASK should be defined in line 131, 132 of stm8_tsl_checkconfig.h. Otherwise compilation fails if multichannels keys are no...
Posted on September 18, 2011 at 19:13I use STM8 Assembler. Code: ...... CLOCK EQU 16000 TIME EQU CLOCK/1000 .... compile error Error 67: Improper Character(s) '/1000' Why? I find :) TIME EQU {CLOCK/1000} Works without errors
Posted on November 13, 2010 at 07:52Hello, I am unable to debug on the STM8L-Discovery using STVD, I always get this error when trying to start a debug version: Connection error (usb://usb): swim error [30004]: comm timeout I tested STVD versions 4....
Posted on September 22, 2011 at 11:20Hi, I'm working on the STM8S-Discovery board with the Cosmic compiler in STVD 4.2.1 patch 2. When debugging and stepping through the code there is no information in the disassembly and memory windows. I'm sure...
Posted on September 21, 2011 at 00:02Hi all,I am working a project that has a SPI master on an OMAP-L138. I had the four lines manually wired across from the OMAP-L138 to the STM8-S discovery board. The connections are below:OMAP SPI CS -> STM8 SP...
Posted on September 14, 2011 at 15:24Hi all, I am busy modifying my code so that I can utilize a custom bootloader. My application code is running and compiling with no problems on its own. The problem begins when I try to shift the start address o...
Posted on September 16, 2011 at 15:34 Hi, I am trying to download my application using the flash loader demonstrator and I am running into a problem at the same point each time - After 82% of the download the communication stops (see attache...
Posted on September 14, 2011 at 14:54I installed STVD 4.2.1/STVP 3.2.3 (Version 24.0) and then tried to install Patch&sharp2 (Version 2.0.0). The patch installation starts but then I get an error window with the title Unhandled Exception with the ...
Posted on September 12, 2011 at 13:08When I write this code: DAC_Init(DAC_Channel_1, DAC_Trigger_Software, DAC_OutputBuffer_Enable); The registers don't change. Maybe I have to write something before? Thank you!
Posted on September 06, 2011 at 19:56I'm looking to measure 50/60Hz using TIM1 and pin PD7 as input has anyone an example of this? Also I don't seem to be able to select the AFR4 in the STDV anyone have a clue why?