SYS in system core is not able to be configured.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2020-02-23 9:03 AM
Hi, I am using an stm32f091rc board and I am trying to configure the systick settings so that I can run Freertos on my board. However, I get the error shown in the picture. Does anyone know a fix for this? I am hoping that it is not a limitation of the F0 architecture, but that may be the case.
Any info is much appreciated.
RESOLVED: needed to update ide
- Labels:
-
STM32CubeIDE
-
STM32F0 Series
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2020-02-23 12:12 PM
It works for me using STM32CubeIDE 1.2.1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2020-02-23 12:49 PM
Are you using stm32F0?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2020-02-23 9:40 PM
Scroll down the "mode" section...
