Hello ST Community,
I am using STM32H7B3 + TouchGFX + 7-inch 800×480 TFT with GT911/GT9111 touch controller.
In the TouchGFX PC simulator, all buttons and toggle switches work correctly. But after flashing to hardware:
- TFT display is working properly.
- Touch is detected.
- Actual touch point and detected touch point are different.
- Touch is detected on the same horizontal line, but the vertical coordinate is shifted/wrong.
I want to know the correct solution for touch coordinate mapping/calibration. Should this correction be done.
Please guide me on the correct method for touch calibration and hardware control/status display in TouchGFX.
Thank you.
