way to isolate stm32 chipset from NUCLEO board?

[KPrem.2]

Hello, I would like to know the way to measure actual power consumption of stm32 chip on NUCLEO board, so if I disconnect:

> LEDs

> voltage regulators (supply 3.3vdc directly instead)

am I able to get power consumption of stm32 chipset according to its specs on datasheet?

Thank you very much.

[Piranha]

All Nucleo boards have a jumper for MCU's current measurement purposes.

[S.Ma]

Nucleo boards can be configured to perform ulpbench measurements. Just remember to disconnect the stlink signals going to the target to be thourough and avoid another post...