RTX Configuration via STM32CubeMX

[jbeloso]

Posted on September 26, 2016 at 11:56

Hi,

I would like to use CubeMX and its grafical interface to generate code for my project in the Keil uvision IDE. I would like to use RTX RTOS too.I only found this tutorial:http://www.keil.com/pack/doc/STM32Cube/General/html/cubemx__r_t_x.html#cubemx_RTX_CubeMXbut this tutorial is for STM32F7, and I am working with Cortex M4 (STM32F4). I made this tutorial step by step but I have an error in the compilaton:error: L6235E: More than one section matches selector - cannot all be FIRST/LAST.Somebody knows what is the problem?? Any tutorial for this??thank you very much.

[slimen]

Posted on September 26, 2016 at 14:52

Hello beloso.julio,

It seem you have a duplicate file names. Check your configuration setting.More details in this

http://www.keil.com/support/docs/3751.htm

.You may review this

http://www.st.com/content/ccc/resource/technical/document/user_manual/10/c5/1a/43/3a/70/43/7d/DM00104712.pdf/files/DM00104712.pdf/jcr:content/translations/en.DM00104712.pdf

about STM32CubeMx for STM32 configuration.Regards

[ingwmeier]

Posted on September 26, 2016 at 16:20

we had a similar message, the cause was 2x inclusion of the startup assembly file in the project